[<<][staapl][>>][..]
Sat Aug 9 14:31:37 BST 2008

Staapler connector

Before the lowlevel boostrap can be solved, I need an adapter dat
converts serial to ICD2 protocol.  Let's combine the Olimex 6-pin
header with the FTDI 6-pin header into a 12 pin double header.  This
allows the use of 2x3 female headers for the Staapler.

How to arrange it? Daisy chaining Staapler should work without trouble
(using one Staapler to program another one). The other alignments can
be taken to simplify GND and VDD connections.


Staapler connector: target board male 2x6 header with ICD2 and TTL232R
serial connector.  This is placed at board edge.  Staapler (outline =
dotted lines) fits on top of this, sticking out (downward) over the
target bord edge (dotted edge).  The serial connector is optional.

  . . . . . . . . . . . . .
  . +-------------------+ .
  . |  1  2  3  4  5  6 | .  ICD2
  . |  7  8  9 10 11 12 | .  Serial (optional)
  . +-------------------+ .
  .                       .
  .  target board edge    .
-----------------------------
  .                       .
  .                       .

ICD2
 1 /MCLR  white
 2 VDD    red
 3 GND    black
 4 PGD    blue
 5 PGC    green
 6 PGM    yellow

SERIAL
 7 GND    black
 8 /CDS
 9 VDD    red
10 TXD    orange
11 RXD    yellow
12 /RTS



[Reply][About]
[<<][staapl][>>][..]